Skip to content
FREE SHIPPING ON PURCHASES OVER $25 FOR ENTIRE CONTIGUOUS UNITED STATES
FREE SHIPPING ON PURCHASES OVER $25 FOR ENTIRE CONTIGUOUS UNITED STATES

How to Connect a WEN Generator Battery with Quick-Connectors

Many WEN generators come equipped with a standard SAE connector for the battery. This post will show you how to connect and disconnect the quick-connectors. For a video demonstrating this procedure, please see below (or click here if the video isn't showing up).

On many WEN generators, the connectors and battery are easily accessible on the side of the frame. Here, they're shown with the rubber covers installed.

WEN generator battery quick-connectors with covers installed

On other generators, you will need to remove an access panel, and on certain models, you’ll need to pull the battery out first. The connectors may be secured by a zip tie; have some wire cutters on hand to cut the zip tie, being careful not to cut the wires or the rubber covers.

WEN generator battery quick-connectors secured with a zip tie.

Pull off the rubber connector covers, then push the connectors together, as shown below.

WEN generator battery quick-connectors properly connected.

That’s it! If applicable, make sure to tuck all the wiring and the battery back into the generator, and reinstall any access panels. When it’s time to store your generator, simply disconnect the connectors and cover them with the rubber covers.

Thanks for reading! If you have any questions after reading this guide or watching the video, please feel free to give us a call at 1-847-429-9263 (M-F, 8 AM to 5 PM CST) or drop us a message at orders@wenproducts.com to speak with our friendly and knowledgeable technical support team.

Previous article How to Clean a Generator's Spark Arrestor
Next article Picking the Perfect Polisher

Leave a comment

Comments must be approved before appearing

* Required fields